M888/842M Cooper 21, 36, 38, & 57, Matte

$34.99
SKU:
M888/842M
Brand:

Maxima®

  • 2 piece base set.
  • 6-48 Screws
Current Stock:

Out of stock

Key Features:
Best Uses:

Description

Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA

The ultimate solution for mounting your optics securely on various rifles, including Fits: Cooper-21, 36, 38, 57, Kimber of Oregon-M82 Hornet, M84: Warne Maxima Steel Bases. These bases aren't just your run-of-the-mill mounts but a testament to strength, versatility, and precision engineering.
With a full-width recoil slot in each base, Maxima Bases ensure maximum contact between your rings and the firearm, making them superior recoil management, and keeping your optics zeroed in shot after shot. Made in the USA.

Fits: Cooper-21, 36, 38, 57, Kimber Of Oregon-M82 Hornet, M84

Specifications

Part Number:
M888/842M
Weight:
1.2 oz
Fits:
Cooper-21, 36, 38, 57, Kimber Of Oregon-M82 Hornet, M84

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.