A997M Marlin Lever Actions Matte Aluminum

$22.49
SKU:
A997M
Brand:

Maxima®

  • 1 piece base.
  • 8-40 screws
Current Stock:

Out of stock

Key Features:
Best Uses:

Description

Lightweight Aluminum.
Firearm Specific Fitment.
Designed and MADE IN USA
The Maxima Aluminum Bases are modeled around the popular we'ver design, which is one of the strongest and most versatile mounting systems available today. The low profile of the Maxima Aluminum Bases give your firearm a sleek look. When used in conjunction with Warne Maxima QD Rings, the shooter is able to utilize the open sights by looking over the top of the bases without sacrificing the normal shooting position behind the firearm. These bases also offer a full width recoil slot in each base. This feature allows the recoil control keys of Warne Rings to attain maximum bearing surface.

Specifications

Part Number:
A997M
Weight:
1.0 oz
Fits:
Henry Lever Gun-H009, H010, H014, Marlin-336, 336C, 36, 30AS, 375, 1894, 1895, 444, Glenfield 30, Zane Grey

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.