M892/868M Rem 742, 760 & 740 Base, Matte

$34.99
SKU:
M892/868M
Brand:

Maxima®

  • 2 piece base set.
  • 6-48 Screws
Current Stock:

Out of stock

Key Features:
Best Uses:

Description

Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA

If you need superior strength without sacrificing versatility, Warne Maxima Steel Bases were designed with you in mind. Modeled after the popular Weaver design, the low profile offers a range of advantages to the shooter.

Keeping the scope mount low allows for optimal cheek weld while still maintaining proper eye relief. Plus, when used in conjunction with Warne QD Rings, you're able to utilize the open sights by looking over the top of the bases without compromising your shooting position.

Maxima Bases also offer a full-width recoil slot in each base. This feature allows the recoil control keys of Warne Rings to attain maximum bearing surface.

All Warne products are designed for shooters by shooters and come with a lifetime warranty.

Fits: Remington 740, 742 or 760 rifle

Specifications

Part Number:
M892/868M
Weight:
1.2 oz
Fits:
Remington 740, 742, 760

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.