M956/956M Remington 504,547, Matte

$34.99
SKU:
M956/956M
Brand:

Maxima®

  • 2 piece base set.
  • 6-48 Screws
Current Stock:
51
Adding to cart… The item has been added
Key Features:
Best Uses:

Description

Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA

If strength and versatility are what you need for your Remington 504 or 547, then Warne Maxima steel bases are for you. They are the strongest and most versatile mounting system available today. Using the simple Weaver low-profile design along with our steel construction, they are a significant upgrade from any other 2-piece bases. Being low profile, they give your firearm a sleek look. When used with Warne Maxima QD Rings, the shooter can utilize the open sights by looking over the top of the bases without sacrificing the normal shooting position behind the firearm. Maxima Bases also offer a full-width recoil slot on each base. This feature allows the recoil control keys of Warne Rings to attain maximum bearing surface.

Fits: Remington 504, 547

Specifications

Part Number:
M956/956M
Weight:
1.2 oz
Fits:
Remington 504, 547

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.