V412/412M Savage 10/110, Browning A-Bolt 3, w/8-40 Screws, Matte Base Set

$15.99
SKU:
V412/412M
Brand:

Vapor®

  • 2 piece base set.
  • 8-40 Screws.
Current Stock:
422
Adding to cart… The item has been added
Key Features:
Best Uses:

Description

Lightweight Aluminum.
Firearm Specific Fitment.
Designed and MADE IN USA

AFFORDABLE, MADE IN USA QUALITY Our Vapor® line of mounts were developed and engineered to provide you with a strong and economical mounting solution that outperforms other mounts in their class.

A Vapor scope base from Warne Scope Mounts offers outstanding performance at an economical price.

If you are on a budget, you'll appreciate the value of Warne's Vapor mounts. Made in the U.S. with lightweight aluminum, the V412/412M two-piece base set with 8-40 screws is a good fit for Savage 10/100 and Browning A-Bolt 3 models. Featuring a matte finish, it is easy to install and offers field-proven performance in a variety of situations without weighing you down.

  • Time-tested designs
  • Easy to install
  • Field proven performance
  • Lightweight aluminum
  • Lifetime warranty
  • Designed and Made in USA

Fits: Browning AB3, HS Precision Savage Style, Pierce Actions, Savage-110 BA (338 Lapua), 110 FCP (338 Lapua), Savage New (All with 8-40 screws)

Specifications

Part Number:
V412/412M
Weight:
0.7 oz
Fits:
Browning AB3, HS Precision Savage Style, Pierce Actions, Savage-110 BA (338 Lapua), 110 FCP (338 Lapua), Savage New (All with 8-40 screws)

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.