V464/464M Marlin Lever Action 336, 1894, 1895, Matte Base Set

$18.99
SKU:
V464/464M
Brand:

Vapor®

  • 2 piece base set.
  • 8-40 Screws.
Current Stock:
23
Adding to cart… The item has been added
Key Features:
Best Uses:

Description

Lightweight Aluminum.
Firearm Specific Fitment.
Designed and MADE IN USA

AFFORDABLE, MADE IN USA QUALITY Our Vapor® line of mounts were developed and engineered to provide you with a strong and economical mounting solution that outperforms other mounts in their class.

  • Time-tested designs
  • Easy to install
  • Field proven performance
  • Lightweight aluminum
  • Lifetime warranty
  • Designed and Made in USA

Fits: Henry Lever Guns-H009, H010, H014, Marlin-336, 336C, 36, 30AS, 375, 1894, 1895, 444, Glenfield 30, Zane Grey, Camp 9, Camp 45, 62

Specifications

Part Number:
V464/464M
Weight:
0.6 oz
Fits:
Henry Lever Guns-H009, H010, H014, Marlin-336, 336C, 36, 30AS, 375, 1894, 1895, 444, Glenfield 30, Zane Grey, Camp 9, Camp 45, 62

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.