Key Features:
Best Uses:
Description
Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA
Warne Matte Black Maxima Steel Bases are precision-engineered to seamlessly accommodate Rifles with the Remington 700 actions (see fits list below) with unmatched strength and adaptability. These steel bases redefine excellence in mounting systems, delivering superior performance in every aspect.
Inspired by the esteemed Weaver design, our Maxima Steel Bases boast a sleek and low-profile silhouette that enhances the visual appeal of your firearm.
Designed to seamlessly pair with Warne Maxima QD Rings, these bases not only enhance stability and precision but also empower shooters to maintain their natural shooting stance while utilizing open sights. The full-width recoil slot in each base guarantees optimal contact with the recoil control keys of Warne Rings, ensuring a reliable and easy-to-use system.
Experience strength and adaptability with the Matte Black Maxima Steel Base, setting a new benchmark for firearm mounting solutions.
Fits: Bergara B-14, BSA Monarch round receiver, Christensen Arms bolt action Rem 700 style, Churchill Highlander, CVA Paramount Muzzleloader, Herters U-9 (drilled and tapped), Howa 1500 & 1700, Mauser Model 18, Mossberg 1500 & 1700, Nosler M48, Raptor Arms
Specifications
Related Products
Installation Instructions
Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
- Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
- Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
- If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
- Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
- If base(s)/rail fit properly, firmly tighten screws.
- WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.
IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.
If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.
