M902/876BB Remington 700, Burnt Bronze

$45.49
SKU:
M902/876BB
Brand:

Maxima®

  • 2 piece base set.
  • 6-48 Screws
Current Stock:
141
Adding to cart… The item has been added
Key Features:
Best Uses:

Description

Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA

Warne Maxima Scope Bases for the Remington 700 action (see other fits below) are today's strongest and most versatile mounting system.

Our Maxima Scope Bases are meticulously crafted from robust steel, making them the epitome of durability and adaptability in the world of mounting systems.

Inspired by the renowned Weaver design, our Maxima Steel Bases boast a sleek, low-profile design that enhances the aesthetics of your firearm. The burnt bronze color adds a touch of distinction to your setup.
These bases pair seamlessly with Warne Maxima QD Rings, enabling shooters to maintain their normal shooting position while still utilizing open sights. The full-width recoil slot in each base ensures optimal contact with the recoil control keys of Warne Rings, enhancing stability and control.

Experience the pinnacle of strength and versatility with Burnt Bronze Maxima Steel Bases, setting a new standard in firearm mounting solutions.

Fits: Bergara B-14, BSA Monarch round receiver, Christensen Arms bolt action Rem 700 style, Churchill Highlander, CVA Paramount Muzzleloader, Herters U-9 (drilled and tapped), Howa 1500 & 1700, Mauser Model 18, Mossberg 1500 & 1700, Nosler M48, Raptor Arms

Specifications

Part Number:
M902/876BB
Weight:
2.1 oz
Fits:
Bergara B-14, BSA Monarch round receiver, Christensen Arms bolt action Rem 700 style, Churchill Highlander, CVA Paramount Muzzleloader, Herters U-9 (drilled and tapped), Howa 1500 & 1700, Mauser Model 18, Mossberg 1500 & 1700, Nosler M48, Raptor Arms
Material:
Steel

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.