Over Built for the task!
The Warne Rimfire rings were created to fits both the 3/8th inch and 11mm dovetails found on many common rimfire rifles. Featuring a unique 70/30 horizontal split design, these steel rimfire rings are the best available.
No products in the cart.
$49.99
Fits 3/8th inch and 11mm Dovetails
The Warne Rimfire rings were created to fits both the 3/8th inch and 11mm dovetails found on many common rimfire rifles. Featuring a unique 70/30 horizontal split design, these steel rimfire rings are the best available.
Firearm Manufacturer or Type | Firearm Model or Type |
---|---|
Firearm Manufacturer or Type | Firearm Model or Type |
Anschutz | Dovetail only |
Browning | A-Bolt 22 Mag dovetail |
Browning | T-Bolt dovetail only |
CZ | 452, 455, 457, 512 W/3/8 & 11mm dovetail |
Henry Repeating Arms | AR-7 Survival Rifle, Pump Action Octagon |
Henry Repeating Arms | Lever Action Rimfire Dovetail Receiver |
Mossberg | Plinkster (3/8 Dovetail Receiver) |
Remington | 597 Dovetail |
Ruger | American Rimfire Dovetail |
Sako | Quad Dovetail |
Zastava | Smallbore Rifle 11mm dovetail |
Select Scope Tube Diameter | Select Objective Size |
---|---|
Select Scope Tube Diameter | Select Objective Size |
30mm Rimfire Dovetail | Up to 44mm obj. |
Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
*Many scope manufacturers’ have established specific torque ratings for their scope and you must follow their recommended torque.Torque Spec are for dry threads, DO NOT USE THREAD-LOCKER COMPOUND
**Rings are factory set for 3/8″ dovetail (dimple up), for 11mm dovetails, remove clamp and re-install with the dimple down.
***Please refrain from tightening QD lever with any hand tool as it is not required.
IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.
⇒ If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.
Rimfire Rings
Rimfire Rings
Picatinny Rails
Rimfire Rings
Picatinny Rails
Rimfire Rings
Rimfire Rings
Rimfire Rings