Key Features:
Best Uses:
Description
Available in Zero or 20MOA
Firearm Specific Fitment
Designed and MADE IN USA
Warne Vapor Picatinny rail for Ruger 10/22 is designed to offer shooters an affordable and reliable mounting platform manufactured for the popular Ruger 10/22.
The V490-15MOA scope base for the Ruger 10/22 offers 15 MOA of elevation built in. An extra 15MOA allows gives you more eleveation adjustment in your rifle scope for pushing the limits of your 10/22 but works perfectly fine for short range work. Works great with red dots and maginfied optics and LPVOs.
Our Ruger 10/22 Picatinny scope mount extends slightly over the receiver to allow a little mounting space for your optic.
Fits: Ruger 10/22 Rimfire, w/6-48 screw receiver
- Precision CNC machined from 6061/T6 aluminum
- Mil-Spec hardcoat anodized finish for abrasion and corrosion resistance.
- Self centering tapered T-15 Torx screws.
- Fits Picatinny & weaver style rings and are NATO-STANAG compatible.
For additional information on 20MOA see our blog post 20 MOA Explained
Specifications
Related Products
Installation Instructions
Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
- Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
- Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
- If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
- Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
- If base(s)/rail fit properly, firmly tighten screws.
- Ruger 10/22 and variants of this firearm have an Aluminum Receiver and extreme caution must be taken while installing scope bases/rails *Taken from the Ruger 10/22 “Attaching scope Base Adapter” instructions, – Starting at the first screw, turn each screw part way in; then move to the next screw, repeating the procedure until all four screws are tightened to a maximum torque setting of 12-15 inch/lb. (Ruger torque values are based on dry threads, no thread-lock compound) Over-tightening will most likely cause the receiver threads to strip out.
*Torque Spec are for dry threads, DO NOT USE THREAD-LOCKER COMPOUND
IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.
If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.
