Zoom
6114M, Red-dot Riser, Picatinny 8-Slot 0.90 inch height 6114M, Red-dot Riser, Picatinny 8-Slot 0.90 inch height 6114M, Red-dot Riser, Picatinny 8-Slot 0.90 inch height 6114M, Red-dot Riser, Picatinny 8-Slot 0.90 inch height

6114M, Red-dot Riser, Picatinny 8-Slot 0.90 inch height

MSRP: $80.99
Was: $80.99
Now: $64.99
(You save $16.00 )
SKU:
6114M
Brand:

Tactical

  • .90 inch Riser
  • EOTECH® Compatible
Current Stock:
249
Adding to cart… The item has been added

Key Features:

  • al-icon.svg
  • an-icon.svg
  • lw-icon.svg

Best Uses:

  • hu-icon.svg
  • ts-icon.svg
  • co-icon.svg
  • lem-icon.svg

Description

Lightweight Aluminum
Picatinny Mount
Designed and MADE IN USA
This product contains chemicals known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov

Designed to raise your red dot optic for a heads-up shooting position with modern sporting rifle platforms, the Warne® Picatinny Red Dot Riser provides a solid, lightweight mounting solution. Precision-engineered for secure attachment to Picatinny rails, it delivers a stable platform for fast, consistent target acquisition.

  • 0.90 inch Riser Height: Designed for use with EOTECH XPS-height optics.

EOTECH is a registered trademark owned by EOTECH, LLC, based in Plymouth, Michigan.

Specifications

Part Number:
6114M
Weight:
2.3 oz
Fits:
Most Red-dot picatinny interfaces

Related Products

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Loosen both cross bolts on the Picatinny Riser Mount and install on your Picatinny-style rail* with the cantilever forward toward the muzzle end of the rifle.
  • Push the mount towards the muzzle and tighten cross bolts to 30 in-lb.
  • Place your optic on the mount in your desired location and tighten the optic to the manufacturer's recommendation.

    • *Warne recommends mounting to the rifle receiver and to avoid mounting to the handguard rail if there is one.

    **Many scope manufacturers have established specific torque ratings for their scope and you must follow their recommended torque.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.

!