M904/922M Browning A-Bolt Shotgun, Matte
$34.99
- SKU:
- M904/922M
- Brand:
-
Maxima®
- 2 piece base set.
- 6-48 Screws
Key Features:
Best Uses:
Description
Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA
Looking to Mount an Optic on your Browning A-Bolt Slug Gun Shotgun? Warne Maxima steel bases are the strongest and most versatile mounting systems available today that can handle the hard-hitting slug gun recoil. The low profile design and steel construction significantly upgrade from other 2-piece bases. The Maxima Steel Bases are modeled around the tried and true Weaver design.
The low profile of the Maxima Steel Bases gives your firearm a sleek look. When used with Warne Maxima QD Rings, the shooter can utilize the open sights by looking over the top of the bases without sacrificing the normal shooting position behind the firearm. Maxima Bases also offer a full-width recoil slot on each base. This feature allows the recoil control keys of Warne Rings to attain maximum bearing surface.
Fits: Browning A-Bolt Slug Gun (Shotgun)
Specifications
Related Products
Installation Instructions
Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
- Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
- Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
- If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
- Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
- If base(s)/rail fit properly, firmly tighten screws.
- WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.
IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.
If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.
