M905M Remington 700 .854" Extension, Matte

$19.99
SKU:
M905M
Brand:

Maxima®

  • 1 piece base extension.
  • .854" rearward offset front base extension
Current Stock:

Out of stock

Key Features:
Best Uses:

Description

Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA

If you are having a problem getting proper eye relief, You may need to move the front scope ring back to achieve the eye relief you need for a consistent check weld. The Warne M905M Remington 700 .854" Extension front base may help you get there. Determine how far back you need to move it to see if the .854" base extension will solve your problem. We also make a .554" extension if you require less space. Check the list below under "fits" to see all the rifles that can help you achieve your desired eye relief.

To be used with Maxima Remington 700 rear base. 

Specifications

Part Number:
M905M
Weight:
1.0 oz
Fits:
FRONT ONLY of All-Carl Gustaf 2000, Navy Arms Country Boy Muzzleloader, Remington 783, Ruger American Centerfire, Savage-10, 11, 12, 14, 16, 110, 111, 112, 114, 116, 220F Slug Gun, Axis, Axis ll, Edge, New 110, Shilen Round Receiver, Stevens-2000, 20

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.