M918/919M Browning A-Bolt WSSM, Matte
$34.99
- SKU:
- M918/919M
- Brand:
-
Maxima®
- 2 piece base set.
- 6-48 Screws
Key Features:
Best Uses:
Description
Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA
Warne Maxima Steel Bases for the Browning A-Bolt WSSM: Warne Maxima Steel Bases. These bases aren't just your run-of-the-mill mounts but a testament to strength, versatility, and precision engineering.
Maxima scope bases are crafted from solid steel and built to withstand whatever challenges you throw at them. Whether hunting in rugged terrain or hitting the range for serious shooting, you can trust Maxima Steel Bases to keep your optics locked in place.
But it's not just about strength; versatility is where these bases truly shine. Compatible with Weaver rings, they offer compatibility with a wide range of scopes and accessories. Their low-profile design adds a sleek look to your firearm without sacrificing functionality.
Pair these bases with Warne Maxima QD Rings; you have a winning combination. Thanks to the low profile design, using the QD rings, you can remove your scope and utilize your firearm's iron sights, a game-changer for fast close-range target acquisition.
And let's talk about recoil control. With a full-width recoil slot in each base, Maxima Bases ensure maximum contact between your rings and the firearm. This translates to superior recoil management, keeping your optics zeroed in shot after shot.
So, whether you're gearing up for a precision hunt or honing your skills at the range, ensure your Browning A-Bolt WSSM is equipped with the best. Choose Warne Maxima Steel Bases for unmatched strength, versatility, and peace of mind. Because when it comes to mounting systems, there's no room for compromise.
Fits: Browning A-Bolt WSSM
Specifications
Related Products
Installation Instructions
Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
- Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
- Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
- If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
- Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
- If base(s)/rail fit properly, firmly tighten screws.
- WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.
IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.
If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.
