M999M Savage Axis/Edge 1 Piece Base, Matte
$55.99
- SKU:
- M999M
- Brand:
-
Maxima®
- 1 piece base.
- 6-48 Screws
Key Features:
Best Uses:
Description
Steel Strength.
Firearm Specific Fitment.
Designed and MADE IN USA
Warne Maxima steel bases offer both maximal strength and versatility. Warne Maxima's simple, low-profile design and steel construction provide a significant improvement over other comparably priced two-piece bases, and Maxima bases are made from aerospace-grade materials. If you're looking for a Savage Axis/Edge scope base, this Maxima two-piece scope base will fit the Savage Axis, Axis II and Edge rifles.
Although the Weaver mounting system is one of the strongest out there, it's also remarkably lightweight. That's why we based our Maxima Steel Bases around it. The low profile allows for optimal cheek weld in any shooting position. Designed for shooters by shooters, Warne Scope mounts give you confidence in every shot.
Specifications
Related Products
Installation Instructions
Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
- Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
- Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
- If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
- Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
- If base(s)/rail fit properly, firmly tighten screws.
- WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.
IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.
If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.
