7677-20MOA Winchester 70 WSM Mountain Tech Tactical Rail, 20MOA

$74.99
SKU:
7677-20MOA
  • 20MOA.
  • Tapered 6-48 Screws.
Current Stock:
28
Adding to cart… The item has been added
Key Features:
Best Uses:

Description

Available in Zero or 20MOA.
Firearm Specific Fitment.
Designed and MADE IN USA

The 7677-20MOA Mountain Tech Tactical Rail for the Winchester Model 70 WSM offers another key advantage: increased scope elevation adjustment. The 20MOA incline built into the Picatinny rail allows shooters to maximize their scope's elevation capabilities, providing the necessary compensation for extreme long-range shots.

In the realm of long-range precision hunting and shooting, where every shot must be calculated with precision, the enhanced scope elevation adjustment offered by the 7677-20MOA Mountain Tech Tactical Rail proves invaluable. It's the difference between hitting your mark with confidence and falling short of your target. With the Warne 7677-20MOA Mountain Tech Tactical Rail, shooters can harness the full potential of their optics and push the boundaries of their shooting capabilities with ease.

  • Precision CNC machined from 7075/T6 aluminum for a high strength & lightweight platform
  • Mil-Spec hardcoat anodized finish for abrasion and corrosion resistance.
  • Bases feature black zinc coated hardware for “Element Proof” protection.
  • Self centering tapered T-15 Torx screws.
  • Fits Picatinny & we'ver style mounts and are NATO-STANAG compatible.

Specifications

Part Number:
7677-20MOA
Weight:
1.8 oz
Material:
7075 Aluminum
Fits:
Winchester Model 70 WSM, 5.23 inch outside holes spacing

Installation Instructions

Always verify that your firearm is UN-LOADED before performing any service on it. Warne recommends that you loosely assemble rings and scope onto firearm prior to final mounting to verify eye relief and ring spacing.
  • Visually inspect your firearm's receiver for burrs around the screw holes and remove if necessary. Remove all oil and grease from the holes in the receiver, the base screws and contact surfaces.
  • Place the base(s)/rail on the receiver. In some instances the front base will overhang the receiver, place base overhang towards the rear of the firearm. Check for proper fit and alignment.
  • If you have short and long screws, please use the short screws in the front of base/rail, front holes of firearm.
  • Using a T-15 wrench (supplied with WARNE rings) loosely install the supplied Torx 15 screws.
  • If base(s)/rail fit properly, firmly tighten screws.
  • WARNE recommends no more than *25 in/lb maximum torque. WARNE recommends the use of a REMOVABLE thread locking compound on base/rail installations only, for best results.

IMPORTANT: NEVER OVER TIGHTEN ANY BASE OR RING SCREW. NEVER ATTACH A SCOPE IF THE OBJECTIVE TOUCHES THE BARREL OR CAUSES INTERFERENCE WITH THE BOLT, SAFETY OR CYCLING OF THE ACTION. ALWAYS FOLLOW THE FIREARM OR SCOPE MANUFACTURERS’ RECOMMENDED TORQUE SPECIFICATIONS. YOU ARE RESPONSIBLE FOR YOUR OWN GUNSMITHING METHODS.

If you are unsure or do not have the proper tools, please contact a gunsmith for assistance, Warne will not be held liable for stripped/damaged receivers or scopes.